This 32 bit brushed flight control is based on SP RACING F3 EVO firmware
Specailly designed circuit ensure 5V output for UART1/2/ despite 1S or 2S input,DSM output at 3.3V
Support basically all coreless motors available, including 1020 motor.
Large current NMOS transistors enable the board to sustain up to 10A operating current per channel. Each channel is equipped with a freewheeling diode.
Dimensions:22MM * 32.5MM, thickness: 1.2MM.
The propeller must be removed during configuration F3 EVO 1.13.0 firmware by default, if you need to reflash, please input “set motor_pwm_rate = 1000” in the Cleanflight configuration software and save!
Set maximum throttle value to 2000 can effectively increase the flight time
Default input is 1S (4.2V); For 2S, first you need to remove the tin on the pads and bridge the right two pads as picture shows, Under no circumstance should the three pads be shorted together.
Other parts you might be interested:
90mm-120mm carbon fiber frame for brushed motors http://www.amazon.com/dp/B01FAM7AZA www.amazon.com/dp/B01MCWZ7VS www.amazon.com/dp/B01KUPB5EY
Self-binding Micro DSM2 DSMX receiver www.amazon.com/dp/B01JWFCRYA
Brushed F3 EVO support 1s&2s quad&hexacopter http://www.amazon.com/dp/B01K1IGCHU
F3 evo brushed with Built-in Frsky Compatible Receiver www.amazon.com/dp/B01MXU45O0
Brush F3 with Built-in OSD Frsky-Compatible 8CH SBUS receiver www.amazon.com/dp/B01N21EMG6
F3 Brushed with 8CH Frsky Compatible Receiver for Tiny Whoop Quad www.amazon.com/dp/B01MRTK20P
FPV Goggle www.amazon.com/dp/B01KTVWTO4 www.amazon.com/dp/B01KTVCD4A
AIO FPV Camera 48CH 25mW www.amazon.com/dp/B01N9E33XA 32CH https://www.amazon.com/dp/B01CCQ9OCE https://www.amazon.com/dp/B01LY0C0NZ
40CH 25mW 200mw Selectable OSD 4.7~26V input https://www.amazon.com/dp/B01NH02B8X